a43d3481

8.5.6. Main transfer

Main transfer 087

1. Hydrotransformer epiploon
2. 35 N. of m.
3. Cover of the main transfer
apply sealant on the adjoining surfaces at installation
the channel of liquid of the automatic transmission has to remain open
after replacement of a cover adjust installation of the leading gear wheel
4. Magnet
5. External holder of a conic roller bearing
6. Case of the main transfer
7. Regulator epiploon
edges of an epiploon it is turned to the regulator
8. Regulator
9. Sealing ring
always replace
10. Cover
11. 10 N. of m.
12. Needle bearing of the regulator
13. External holder of a conic roller bearing
remove and establish only with a heated adjusting ring
14. Half shaft flange epiploon
before installation fill
space between epiploon edges multi-purpose grease
the epiploon can be replaced without removing the transmission
15. Half shaft flange
16. 25 N. of m.
17. Sealing ring
always replace
18. Adjusting ring
when using old bearings, note the provision of installation of an adjusting ring before removal and use these marks at installation
19. Leading gear wheel
together with a gear wreath
20. Internal holder of a conic roller bearing
adjust installation of the leader
gear wheels after replacement of a holder
21. Epiploon plug
adjust installation of the leading gear wheel after replacement of an epiploon
22. External holder of a conic roller bearing
23. First epiploon of the leading gear wheel
24. 35 N. of m.
25. Second epiploon of the leading gear wheel
26. Epiploon
27. Sealing ring
always replace
28. Cover of the leading gear wheel
adjust installation of the conducting gear wheel after replacement of a cover
29. Internal holder of a conic roller bearing
adjust installation of the conducting gear wheel after replacement of a holder
30. Adjusting washer of S3
31. Adjusting washer of S4
32. Clamp
33. Spring washer
34. 8 N. of m.
35. Adjusting ring
establish together with a sealing ring, an epiploon of a flange of a half shaft and an external holder of a conic roller bearing
36. Bolt
37. Sealing ring
always replace
38. Speedometer drive
39. Bracket
after installation the bracket has to adjoin densely to a case, adjust or replace if it is necessary
40. 8 N. of m.
41. Differential
at installation of a new box, adjust installation of a gear wreath
42. Second epiploon of the leading gear wheel
remove by means of the VW 681 tool
43. First epiploon of the leading gear wheel
remove by means of the VW 681 tool
44. Sealing ring of the oil channel
always replace

The epiploon of the main transfer / transmission is established in a case of the main transfer, at the same time the pressurizing edge adjoins to a regulator mechanism fillet in the transmission.

If you need to replace only epiploons, the transmission and the main transfer should not be inclined at separation to avoid loss or mixing of oil.


Prevention

When replacing the main transfer or the transmission, it is necessary to check an axial gap and, if necessary, to adjust.

Do not start the engine and do not tow the car at the removed oil pallet or when in the transmission there is no oil.

The block of valves can be removed and installed without removing the transmission from the car.