10.3.5. ABS elements of back brakes
The ABS elements of back brakes (models till January, 1989)|
1. Grease the sensor of speed of rotation of a wheel with liquid of the brake cylinder before installation | 6. Wheel nave 7. Wheel bearing 8. Forelock 9. Oil cap 10. Nut 11. Persistent washer 12. Internal holder of the wheel bearing 13. 30 N. of m. 14. Wheel nave pin 15. 10 N. of m. 16. Uplotnitelnov always replace a ring |
The ABS elements of back brakes (models after January, 1989)
| 1. Zadny Bridge is on sale as a zalasny part with the installed plug for fastening speed sensor 2. An arm for fastening of wires лрикрепив them to the suspension bracket lever 3. 10 N. of m. 4. Rotor remove gradually, inserting a mandrel into wheel nave openings 5. Wheel nave 6. Internal holder of the wheel bearing 7. Persistent washer 8. Forelock always replace 9. Lock ring 10. Oil cap | 11. Nut 12. Wheel bearing 13. 30 N. of m. 14. Antisplash guard 15. Wheel nave pin 16. Fixing plug for installation: grease with liquid of the brake cylinder and insert into a rack nest against the stop 17. Sensor of speed of rotation of a wheel it is identical to the left and right parties for removal just pull out it from a nest for installation check a free wheeling of the bearing of a sgtitsa of a wheel and adjust it if it is necessary, before installation of the sensor insert into a nest fingers against the stop |
The ABS elements of back brakes (all-wheel drive models, release till January, 1989 of release)
|
1. Rack of the wheel bearing
is on sale as spare it is frequent with the installed plug for strengthening of the sensor of speed 2. Самоконтрящаяся nut. inhaling moment: 320 N. of m. always replace twist and turn off, only when the car costs on the earth apply D6 glue on a nut carving at its installation |
3. 10 N. of m. 4. Sealing ring always replace 5. Speed sensor 6. Half shaft, CV JOINT and rotor the external CV JOINT is on sale as the spare part with the established rotor |
The ABS elements of back brakes (all-wheel drive models, release since January, 1989 of release)
| 1. Half shaft, CV JOINT and rotor is on sale as spare often established rotor the half shaft does not stick together with a wheel nave the number of teeths on a rotor is reduced by a half in comparison with old modification get the speed sensor before removal of a half shaft from a wheel nave a little 2. Rack of the wheel bearing is on sale as the spare part with a nest for installation of the plug and the sensor of speed 3. 120 N.m. always replace twisting post till the required moment of an inhaling turn dololnitelno on a quarter of a turn (90 °) twist and turn off, only when the car costs on the earth | 4. Fixing plug for installation: grease with brake fluid and establish in a rack nest against the stop 5. Speed sensor it is identical to the left and right parties for removal, just get it from a nest for installation: establish in a nest by fingers against the stop |