10.3.5.1. Sensors of speed of rotation of back wheels
Removal
| PERFORMANCE ORDER |
|
1) remove a fastening bolt (it is specified by an arrow) and get the speed sensor |
| 2) replace a sealing ring of the sensor of speed |
| 3) grease a sealing ring and the sensor with lubricant of the mechanism of brakes |
|
4) install the sensor in a rack nest so that the polyvinyl chloride tip concerned a rotor on the CV JOINT
Prevention
After the sensor of speed was removed and installed several times, replace an old polyvinyl chloride cap and establish new, a detail 437 927 809. It is necessary for maintenance of the required air gap.
5) establish a new fixing bolt and tighten it to 10 N. of m, holding the speed sensor, having pressed it to a hug bearing rack
| 6) insert the rubber plug of wires into an arm on a hug bearing rack |
|
|
Both sockets of connection of sensors of speed of rotation of back wheels are installed under back sitting.
Rotor, installation
Acceleration switch, removal / installation
|
|
the arrow and on the switch specifies on in front of the car |
Arrangement: under back sitting on the left side.
At removal / installation, switch off ignition.
Do not install the switch of longitudinal acceleration on the car on which it was not established by production. On the cars released since April, 1988 this switch is installed.
The switch of longitudinal acceleration is not required for effective work of ABS.
The sensor of speed of rotation of wheels, installation (all-wheel drive models, release till January, 1989 of release)
| PERFORMANCE ORDER |
|
insert rubber plugs of the sensor into an arm on the suspension bracket lever (are specified by shooters) |
|
Both sockets of connection of sensors of speed of rotation of back wheels are under back sitting.
Rotor, installation
Removal / installation
| PERFORMANCE ORDER |
|
1) remove a fastening bolt (it is specified by an arrow) and get the speed sensor |
| 2) replace a sealing ring of the sensor of speed |
| 3) grease a sealing ring and the sensor with lubricant of the mechanism of brakes |
| 4) install the sensor in a rack nest so that the polyvinyl chloride tip concerned a rotor on the CV JOINT |
| 5) establish a new fixing bolt and tighten it to 10 N. of m, holding the speed sensor, having pressed it to a hug bearing rack |
| 6) insert rubber plugs of wires into arms on a hug bearing rack |
|
Both sockets of connection of sensors of speed of rotation of back wheels are under back sitting.
