10.3.4.1. Sensors of speed of rotation of forward wheels
Removal
| PERFORMANCE ORDER |
|
1) remove a fastening bolt (it is specified by the lower arrow) and get the speed sensor |
| 2) replace a sealing ring of the sensor |
| 3) grease a sealing ring and the sensor of speed with the same lubricant that it was used for lubricant of the mechanism of brakes |
| 4) install the sensor in a rack nest so that the polyvinyl chloride tip concerned a rotor on the CV JOINT |
| 5) establish a new fixing bolt and tighten it to 10 N. of m, holding the speed sensor, having pressed it to a hug bearing rack |
| 6) insert the rubber plug of wires into an arm on a hug bearing rack (it is specified by the top arrow) |
|
After the sensor of speed was removed and installed several times, replace an old polyvinyl chloride cap and establish new, a detail 437 927 809. It is necessary for maintenance of the required air gap.
Plait of wires of the sensor of speed of a forward wheel, installation
| PERFORMANCE ORDER |
|
put on the rubber plug (the top arrow) a plait of wires and stretch it to a hug bearing rack
insert a plait of wires in the rubber plug into an arm on a body (the lower arrow)
fix a plait a wire by means of a clip in the point specified by an average arrow |
|
Sensor of speed of the left forward wheel, detachment
| PERFORMANCE ORDER |
|
remove the connection socket from an arm (it is specified by an arrow) and disconnect it from the sensor |
|
Sensor of speed of the right forward wheel, detachment
| PERFORMANCE ORDER |
|
weaken a fixing collar (it is specified by an arrow) remove the socket of connection and disconnect it from the sensor |
|
