8.3.5. Driveshaft
Driveshaft (4x4)
1. Transmission 2. Epiploon 3. 55 N. of m, самоконтрящийся 4. Adjusting washer 5. 20 N. of m. 6. Back differential clear a tap a carving of fixing openings before installation of the driveshaft
|
7. Driveshaft
8. Plate
9. Transmission flange
clear a tap a carving of fixing openings before installation of the driveshaft |
The driveshaft is not subject to repair. If there is a noise or vibration of the driveshaft, check the accuracy of installation of the driveshaft. If adjustment does not fix a problem, it is necessary to replace all driveshaft.
During the work with the driveshaft the car has to be installed on the elevator or on a repair hole.
Removal / installation
| PERFORMANCE ORDER |
| 1) remove the catalytic converter and an exhaust pipe |
| 2) tie up an exhaust pipe to a body on the right |
| 3) weaken bolts of a flange of the transmission, back differential and the central support |
| 4) install the tool 3139 on the driveshaft and tighten plastic nuts |
Prevention
The white point on a back flange of the driveshaft has to coincide with a black point on a flange of back differential at installation of the driveshaft. If these points are not visible, note mutual position of the driveshaft and a flange of back differential before removal of the driveshaft.
|
| 5) remove bolts of fastening of the driveshaft to a flange of the transmission and back differential |
| 6) prop up the driveshaft and the tool 3139 and remove bolts of the central support |
| 7) remove together the driveshaft and the tool 3139 |
| 8) installation is carried out upside-down removals |
Prevention
Do not bend the driveshaft. You store and transport it only in the straightened situation.
|
| 9) always check the accuracy of installation of the driveshaft after completion of installation |
|
Moments of an inhaling of threaded connections
| Fastening of the driveshaft to the transmission |
55 N of m.
|
| Fastening of the driveshaft to back differential |
55 N of m.
|
| Fastening of the central support to a body |
20 N of m.
|
Adjustment
Exact adjustment is necessary for equal and silent work.
| PERFORMANCE ORDER |
| 1) remove an exhaust pipe and the catalytic converter |
| 2) tie up an exhaust pipe to a body on the right |
| 3) weaken bolts of the central support |
| 4) install the tool 3139 on the driveshaft and tighten plastic nuts |
| 5) remove bolts of fastening of the central support and adjusting washers |
|
6) measure distance and, the gap has to be identical on both parties |
|
Definition of the central situation
| PERFORMANCE ORDER |
| 1) move by means of the tool 3139 the driveshaft back against the stop |
|
2) note the provision of a fixing arm on a body (arrow A) |
| 3) move by means of the tool 3139 the driveshaft forward against the stop |
| 4) note the provision of a fixing arm on a body (arrow B) |
| 5) establish a fixing arm in the middle between two marks (an arrow C) |
| 6) establish bolts and washers of the required thickness, tighten bolts to 20 N. of m. |
| 7) remove the tool 3139 |
| 8) establish an exhaust pipe and the catalytic converter |
|
