8.3.2. Removal and installation of the transmission
Removal
| PERFORMANCE ORDER |
| 1) disconnect a wire of the negative plug of the accumulator |
| 2) turn off three top bolts of fastening of the engine and the transmission |
| 3) disconnect a wire of grounding of the transmission from the transmission |
| 4) remove sockets of connection of the sending device of a speedometer and the multi-function sending device |
| 5) disconnect wires from the sensor of content of oxygen and a heating element of the sensor |
| 6) remove a protective plate of the engine |
| 7) disconnect an exhaust pipe from a collector |
| 8) separate an exhaust pipe behind the catalyst and remove a pipe and the catalyst |
| 9) remove the driveshaft |
| 10) remove a back cross beam |
| 11) remove a bolt of fastening of thirst of gear shifting for the transmission and leave draft to hang |
| 12) remove a protective plate of the transmission |
| 13) remove the filter of the right half shaft |
| 14) disconnect half shafts from the transmission, turn a steering wheel against the stop to the right and fix half shafts having tied them to a body |
| 15) remove the working cylinder of coupling |
| 16) disconnect cross draft from a shaft of a steering column and turn wheels to the left |
| 17) install the engine on a support |
| 18) install the transmission on a support |
| 19) remove fastening on a back left part of the transmission and forward fastening of the engine |
| 20) remove the thermal screen from the rubber plug |
| 21) remove an arm of fastening of the rubber plug from the transmission |
| 22) remove the rubber plug |
| 23) remove a bolt directing a seat belt tension rope on a back left part of the transmission. Remove ropes that they did not prevent removal |
|
24) lower a back stretcher on the left side, having turned off fastening bolts (are specified by shooters) |
| 25) remove the remaining bolts of fastening of the transmission and engine |
| 26) remove the transmission |
|
Installation
Installation is made in the sequence, the return to removal. At installation pay attention to the following:
install the working cylinder of coupling into place by means of the lever so that the bolt was inserted easily.
Prevention
Check that centering plugs were installed in the block of cylinders before installation.
Moments of an inhaling of threaded connections
| Fastening of the transmission to the engine |
| M8 bolts |
25 N of m.
|
| M10 bolts |
45 N of m
|
| M12 bolts |
65 N of m.
|
| Fastening of the leading shaft to a flange |
| M8 bolt |
45 N of m
|
| Bolts of fastening of a stretcher |
| M10 bolts |
35 N of m.
|
| after an inhaling to turn in addition on 90 ° (a quarter of a turn) |
| M8 bolt |
55 N of m.
|
Bolts of fastening of cross thirst for a shaft of a steering column
|
45 N of m.
|
Fastening of the transmission to the engine
|
|
1. M12x70 bolt
2. M12x70 bolt
3. M12x90 bolt
4. M12x80 bolt
5. M8x40 bolt
6. M10x50 bolt
7. M10x40 bolt
8. M8x40 bolt
9. M10x120 bolt
10. M12x100 bolt
11. M12x70 bolt
Centering plugs: points 3 and 11 |
