8.2.4. Differential mechanisms
Differential assembled
|
1. Differential case
when replacing the case of differential adjust installation of a zbchaty wreath 2. Bolt of a gear wreath use bolts only of the required specification tighten evenly in a diagonal order to 90 N. m. 3. The big roller bearing – an internal holder to establish by means of the plug 40-21 4. Speedometer drive gear wheel it is possible to remove, without removing the transmission 5. A big roller bearing – an external holder establish by means of the VW 295 and VW 551 tools 6. S1 washer, note thickness 7. Cover 8. Persistent washer before installation oil gearbox |
9. Satellites 10. Axis of satellites remove by means of a drift after removal of a pin of an axis of satellites 11. Pin of an axis of satellites remove by means of a drift 12. Gear wheels of half shafts 13. Gear wreath the gear wreath and the leading gear wheel are adjusted to each other when replacing couple a gear wreath / leading a gear wheel carry out adjustment installation: heat to 100 °C and establish by means of centering pins 14. A small roller bearing – an internal holder to establish by means of the plug 40-21 15. A small roller bearing – an external holder 16. S2 washer note thickness |