8.2.2. Lever mechanism of the lever of gear shifting
Gear shifting lever assembled
1. Gear shifting lever
it can be inserted into a spherical support only in one situation
2. Lock ring
always replace
the roundish party has to be turned to a spherical support
remove before removal of a spherical support
3. 25 N.
4. Lamellar spring
5. Coulisse
6. Draft of gear shifting
color code: blue = for engines with 5 cylinders
7. Cover
8. Clip
9. 25 N. of m.
10. 20 N. of m.
always replace
the screw is greased with sealant
11. Gear shifting lever basis
fastens on a floor by means of AKD 512 001 sealant
12. 10 N. of m.
13. The switching fork
14. 10 N. of m.
|
15. The directing cup
it is necessary to set restrictions for the movement of a spherical support at the left and on the right
establish an emphasis so that at inclusion of transfer of a backing the lever was inclined to the left
16. Spherical support
establish a spring and the plug in a spherical support, and then install the gear shifting lever so that the spring and the plug were on the correct party in the direction of movement
establish a spherical support before installation of a stoprny ring
17. Plug
the roundish end is turned to the gear shifting lever
18. Spring
19. Gear shifting lever axis
20. Expansion plug
21. Lock ring.
22. Cover
for removal unscrew the screw
23. Screw
24. Handle |
Prevention
Do not grease the lever mechanism of the lever of gear shifting.
Adjustment
| PERFORMANCE ORDER |
| 1) move the gear shifting lever to neutral situation
|
| 2) remove the lever handle, unscrew the screw of fastening of a cover of the lever and remove a cover |
|
3) weaken a bolt (it is specified by an arrow)
|
| 4) install the gear shifting lever vertically (as far as possible) |
|
Check
| PERFORMANCE ORDER |
|
1) install the gear shifting lever so that both uvulas on a spherical support were at identical distance of "a" (it is specified by shooters) from the directing cup |
| 2) tighten a bolt and check that the lever did not move
|
| 3) check operation of the mechanism of gear shifting, include all transfers in turn
|
| 4) 3-ya/the 4th transfers have to be in the same plane, as neutral |
| 5) check work of a safety latch of transfer of a backing. If it does not work, turn off screws and turn the directing cup a little
|
| 6) establish a cover and the handle of the lever of gear shifting
|
|
