10.2.3. Main brake cylinder / servo cylinder of the brake system
Prevention
Main brake cylinder / servo cylinder of the brake system
|
1. Tank of brake fluid
with the indicator of level of brake fluid 2. Cap moisten in brake fluid and establish in an opening of the main toromozny cylinder install a tank of brake fluid in openings of caps 3. Air descent opening valve always pump over the main brake cylinder after removal / installation slightly grease a carving of the valve and an opening with liquid of the brake cylinder 4. Pipeline of the brake system 5. Main brake cylinder diameter: 23.81 mm 7. Air descent opening valve slightly grease a carving of the valve and an opening with brake fluid before installation 8. Distributive valve it is not regulated 9. 25 N. of m. 11. 10 N. of m. 12. 20 N. of m. 13. Arm 14. Filter |
15. Sealing ring establish on an arm before installation of a servo cylinder of the brake system then move to the dashboard 16. 20 N. of m. 17. Pipeline of the brake system 18. Sealing ring always replace 19. Extender 20. Alarm switch Inhaling moment: 20 N. of m. 21. Return pipeline 22. Pipeline of high pressure goes to pressure accumulator 23. Servo cylinder do not press a brake pedal at the removed main brake cylinder check on tightness: at the switched-off engine weaken connection of the return pipeline if the servo cylinder is not tight, it will pass liquid (emergence of rare drops is normal) 25. Fork 27. Dashboard 28. 25 N. of m. 29. Pedal arm |
Fork, adjustment
| and = 226.0 (0.5 mm) |
The fork has to is at right angle to a servo cylinder surface when carrying out measurements.