2.3. Carburetors
The ITS carburetor 2 with working components|
1. Safety locks |
13. The soaking-up collector 14. Bolt, 20 N. of m. 15. Au-shaped ring 16. A heater of the bringing collector 17. Bolt, 10 N. of m. 18. Equipment for control of the carburetor 19. Connecting plug 20. A plug for connection of the probe Lambda 21. Probe Lambda, 50 N. of m. |
Top part of the ITS carburetor 2
| 1. Ventilating tube of float-operated cameras 2. Ventilating strainer of the muffler flame (float-operated camera) 3. An enrichment tube at full loading 4. Bolt, 5 N. of m. 5. Start-up gate 6. Carburetor cover 7. Needle 8. Laying, is subject to obligatory replacement 9. Preliminary spray, 1 camera 10. Preliminary spray, 2nd camera |
11. Safety wedge 12. Fuel jet of idling 13. Main jet, 1 camera 14. Main jet, 2nd camera 15. Stopper 16. Arm 17. Regulator of installation of a diaphragm 18. Fixing ring 19. Needle valve of a float 20. Float axis 21. Float 22. Laying of a float |
Lower part of the ITS carburetor 2
|
1. Cap stopper
2. Au-shaped ring 3. Filter 4. Regulator of a butterfly valve 5. Ventilating valve 6. Valve of removal of air 7. Holder of the regulator of a butterfly valve of a rope of gas 8. Backpressure valve 9. Valve plate 10. The directing element 11. Valve spring |
12. Lower part of the carburetor 13. Heater of the valve of average loading 14. Persistent screw of a butterfly valve, camera 1 15. The adjustment screw WITH 16. Vacuum regulator of ignition, camera 2 17. Lever of blocking of a butterfly valve, camera 2 18. Connecting plug 19. Potentiometer of a butterfly valve |
The ITS carburetor 2 in disassembled state
Specifications
Type – 2-ITS, applied in engines 1.6 liters with the designation PP
|
Camera 1P
|
Camera 2
| |
| Diameter of the diffuser |
22
|
26
|
| Main jet |
X 105
|
X 110
|
| Jet air |
X 110
|
X 105
|
| Fuel jet of idling |
X 45
| |
| The channel of enrichment of mix at full loading |
0.4 mm
| |
| The increased speed of idling of the cold engine |
1400 rpm
| |
| Idling rotation speed |
750 rpm
| |
| Content of carbon monoxide |
0.6%
| |
The carburetor 2-ITS is the carburetor of the overturned type, two-step with electronic adjustment. This carburetor has no traditional auxiliary systems of the main fuel system, for example, of the equipment of work of start-up or the accelerating pump. Functions of these systems are performed by two regulators: regulator of position of the gate and regulator of installation of a throttle. Regulators receive electric impulses from a microprocessor control system which is placed behind the hiding place case.
The probe a lambda is in the forward muffler of system of an exhaust. It carries out measurement of content of carbon monoxide in exhaust gases and sends the corresponding signal (tension) to a control system. Thanks to it the equipment of management changes a ratio of fuel and air, soaked up in the carburetor, and thus optimalizirut burning conditions.